01-01-2025 06:26 PM
This is my setup,
All AX86U Pro (primary) connected with cat6 to the modem going to WAN of 86
From a LAN port of the primary 86 to the WAN port of another AX86U Pro (secondary)
All the white LEDs are on (power, 5, 2.4, and WAN) of both 86’s.
A thirds router a AX58U V2 is sitting a short distance away connected only wirelessly with only these three, white LED’s on power, 5, and 2.4. The WAN LED is not lit.
Checking all three routers, all indicate a status of “Unable to reach” and they all show the Network Name of the proper networks of 2.4 and a 5. I. I have limited, mostly zero, luck getting connected to the GUI.
Solved! Go to Solution.
01-05-2025 06:14 PM
Hi @Buk ,
Thank you for providing detailed information about your issue!
Based on your description, your AiMesh system’s lights indicate normal status, but all three routers are unable to connect to the GUI.
We recommend following these troubleshooting steps:
Check AiMesh Node Configuration:
Perform a Hard Reset and Re-add Nodes:
Refer to Related FAQs: If the above steps do not resolve the issue, we recommend referring to the relevant FAQs for further troubleshooting. [Troubleshooting] Why am I unable to access my ASUS router’s settings page? | Official Support | ASU...
Thank you.
01-02-2025 02:12 AM
Can you connect a computer via Ethernet to the primary AX86U Pro LAN port and open web browser to 192.168.50.1 (or whatever IP you may have changed it to)?
01-02-2025 08:26 AM
My devices do not have RJ45. I will try wireless method later this afternoon (Thu Jan 2, 2025) and {explain result) thank you
01-03-2025 04:38 PM
Three routers (2 of AX86U Pros, 1 of AX58U ) AX58U WAN to Primary AX86U Pro LAN. Secondary AX86U Pro WAN to Primary AX86U Pro LAN. All lights lit on all three routers (power, 5, 2.4, and WAN).
All three routers indicate can not reach. All three were set to default mode using proper ASUS__XX. All three programmed with same network and password, admin and password.
Unable to connect to “GUI”
01-03-2025 05:12 PM - edited 01-03-2025 05:14 PM
The primary router (connected to modem) should be set up first. Hard/Factory reset the remaining (nodes as ASUS calls them). Log into the primary router Web interface and add the others as nodes: