- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-06-2021 05:41 AM
I bought a zenbook 14 ux435EG just this May. Everything was fine but after some system updates from windows, I can't seem to tap on the apps on the screenpad.
When I turn on the laptop, the screenpad turns on, the apps can be seen, but when I try to tap or use the screen, it's as if the screenpad functions as a mere motion sensor. On screenpad mode (F6), what I get is a gray pointer instead. The mousepointer vanishes.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-19-2021 12:41 AM
animepuppyHi there,Hi,
Same issue here after microsoft update on my UX435EG-AI016T.
Awaiting for the official solution, if any.
View post
Please run the Screenpad 2 Optimizer again to adjust the screenpad again.
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-06-2021 07:51 PM
Can you share some screenshot or video of the issue?
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-09-2021 01:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-09-2021 01:15 AM
edwardpodestaHave also updated bios, done factor reset, updated all drivers...I'm getting something similar. Movements are tracked, but in mirror (up is down, left is right etc). Doesn't register clicks on screenxpert apps.
View post
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-10-2021 10:47 AM
