Network rules - Smart Connect Rule question

[Valdo]

In attachment is a screenshot of my XT9 Smart Connect Rule.

What is weird or perhaps a bug, that in Steering Trigger Condition - VHT in 5GHz-2 is possible to select only AC Only, but in 5GHz-1 is possible to select All also including AX. The same situation is in STA Selection Priority - VHT.

The only place where is possible to select All in VHT for both 5GHz frequencies is in Interface Select and Qualify Procedures (note that the frequency columns are reversed in relation to the previous entries at the top)

Maybe somebody (except Maximilian!) has an idea whats going on as some of my AX devices are connecting to 5GHz-2 but then apparently are using lower speed, that of AC wifi?!

Firmware: 3.0.0.4.388_24709-g15d5e47

[Aureliannn_ASUS]

Hi @Valdo ,

Regarding your issue, we would like to confirm the following points:

1. Are you referring to AX devices being incorrectly identified as AC devices when connected to the 5GHz-2 band?
2. Do AX devices have any issues when connected to the 5GHz-1 band?
3. If the 5GHz-2 band is set to "AC Only," theoretically, only AC devices should connect to that band.

Please assist in confirming these details.

We greatly appreciate your understanding and cooperation.

[Valdo]

1) I mean that it is not possible to select AX mode, nor other mode except AC

2) They don't, but as it's not possible to select AX in the GUI (there's no other option than AC), they seem to connect in AC. I have no way of verifying this.

3) Yes, because there is no option other than AC Only.

@Aureliannn_ASUS