This widget could not be displayed.
This widget could not be displayed.
cancel
Showing results for 
Search instead for 
Did you mean: 

Rog 3 recording issue with Asus tuf cu4k30 capture card

ehunt22
Star III
Hi,
When I connect my Rog 3 to my laptop using the Asus tuf cu4k30, i get a message on the phone screen that refresh rate is restricted to 60 hz
Based on some research and asking around, it seems this is because the Rog 3 is limited to RGB colorspace
If it can run in YUV colorspace, we would be able to get higher refresh rates while recording
Request moderators to please check with dev team to check for a solution to enable this
@Mattias_ASUS please help with this
45 REPLIES 45

HexHyte
Rising Star I
Danishblunt

https://zentalk.asus.com/en/discussion/comment/228545#Comment_228545

He probably casts his phone to a PC and streams from there, thats why the quality of his stream is bad and its not fluid. You can also the the crunching bitrate and fluctuating framerate on his videos where he streams.

https://www.youtube.com/watch?v=xdWuwx3ypDw

This is what he did in a nutshell. I assume he didnt use the built in casting as on A10 it was horrid, he probably used something else to cast.

https://www.youtube.com/watch?v=JEUe9NZs3kg

This is a proper capture card gameplay video from my phone. Its a high motion game, the image is very clear, the motion is consistent and fluid.


View post
At this point you, @Danishblunt are doing liberal defamation on me which is unacceptable.
You THINK i am casting just because you THINK that my streams are "bad" and not "fluid". This is plain stupidity. You have no proof i am actually casting. Casting by having a friggin Elgato is dumb, Casting on WiFi will increase delay and will negatively impact on internet stability even with an high-end router which is a NO-GO for me. That's why i bought a friggin capture card in the first place!
My english vocabulary is not adequate enough to express how ridiculous and unfounded your claimings are; starting from the fact that on my channel no video was ever recorded using a Rog Phone 3 at all!! All the video Streams you can currently see on my channel were recorded using a ROG PHONE 2 through the Elgato 4k60 Pro MK2.
AS I SAID BEFORE the Rog Phone 3 CAN AND DO mirror himself using 1080p 120hz EDID transmission mode (call it how you want) using the Elgato Card and at this point i could actually post a simple video but i hate the fact that i have to waste my time and effort because you cant stop your god complex.

Danishblunt
Hall of Fame I
Ehunt:
Maybe upload a video to your youtube account and post a link to check it

You:
Sure, I will do it later.

After my reply i played a bit more while streaming and unfortunately i've noticed lot of frame drop when the phone is transmitting through TypeC. -

i could actually post a simple video but i hate the fact that i have to waste my time and effort because you cant stop your god complex.
First you say "sure", then you get to "Oh lots of framedrops!" then "I refuse cuz insert dumb ass reason."

Do us all a favor and stop wasting our time, thanks.

zxops47
Rising Star I
Also i think you will need usb 3.1 gen 2 usb cable with hub usb 3.1 gen 2 because 1080p 120 fps need above 7.46 Gbps

Danishblunt
Hall of Fame I
zxops47

Also i think you will need usb 3.1 gen 2 usb cable with hub usb 3.1 gen 2 because 1080p 120 fps need above 7.46 Gbps


View post
No, since all that matters is the video output, any type C to HDMI 1.4b or greater will do just fine.

ehunt22
Star III
Danishblunt

https://zentalk.asus.com/en/discussion/comment/229025#Comment_229025

No, since all that matters is the video output, any type C to HDMI 1.4b or greater will do just fine.


View post
If the shopping portals would specify this, it would be great. But they usually only state 4k60 and the sort, so hopefully there is a correlation between the two