[ROG Phone II] How to turn on the ROG Kunai Gamepad's cursor mode?

FAQBotFAQBot admin
edited September 2020 in FAQ

When Cursor Mode is turned on, a cursor will appear on the screen. This allows you to use the cursor to access the controls or the virtual buttons on the screen when the touch screen is not active (e.g. when Key Mapping is turned on).

Please follow the steps below:

1. You must first connect your phone to the ROG Kunai Gamepad and launch a game, then you can turn on this function.

 Refer:[ROG Phone II] How do I assemble the ROG Kunai Gamepad (ROG Kunai holder + ROG Kunai controllers)?

      [ROG Phone II] How do I set up the connection for the ROG Kunai Gamepad?


2. When the connection is successful, click the FUNCTION button on the holder.

3. Cursor will appear on the screen.


4. Use the right joystick to control the cursor. Use the L1 button on the left controller to touch virtual buttons on the screen. You can move the cursor around the screen with the right joystick; then press L1 button on the left controller to touch the virtual button (e.g. as shown below).

This discussion has been closed.